PVC 90-Degree Elbow Fitting (1/4 Bend)

Make sharp, precise directional changes in your pipeline runs with our heavy-duty Schedule 40 PVC 90-Degree Elbows. Commonly referred to in the trades as a 1/4 bend, this fitting is engineered to redirect piping pathways at a right angle, maximizing space efficiency across plumbing, drainage, and low-temperature appliance venting lines.

Featuring precision-molded slip sockets on both ends, this elbow forms a permanent chemical bond via solvent welding. It provides an airtight, leak-proof joint that is stronger than the pipeline itself.

Key Features & Benefits

• Right-Angle Directional Shifts: The 90-degree bend allows you to turn corners cleanly, hug walls, and route pipes neatly through tight structural framing or ceiling joists.
• Corrosion & Acid Immunity: 100% immune to electrochemical rusting, scaling, and pitting from aggressive household wastewater or acidic high-efficiency furnace flue condensates.
• High-Impact Rigid Construction: Molded from premium solid-wall PVC compounds to deliver excellent tensile strength and structural crush resistance under active system stress.
• Optimized Interior Finish: Ultra-smooth inner walls eliminate fluid and air friction, preventing the buildup of debris, sludge, or condensation within the bend.
• Deep Socket Depth: Engineered with elongated slip sockets to maximize surface-area contact for a secure, fail-safe solvent weld.

Versatile System Applications

An essential directional fitting designed to guide pipelines across multiple critical infrastructures:

• High-Efficiency Venting: Routing exhaust and intake lines for Category IV condensing furnaces, boilers, and tankless water heaters through exterior sidewalls or roofs.
• Plumbing DWV Stacks: Turning vertical or horizontal drain, waste, and vent networks around corners or directing waste lines into main drainage branches.
• Radon Mitigation Layouts: Directing sub-slab depressurization pipes cleanly out of the floor and up toward roof exhaust points.
• Irrigation & Water Distribution: Turning corners in cold-water supply lines and landscaping piping networks smoothly.

Technical Specifications

• Connection Type: Slip x Slip (Socket x Socket)
• Material: Rigid Polyvinyl Chloride (PVC)
• Wall Rating: Schedule 40 (Solid Core)
• Standards Compliance: ASTM D2466 (Schedule 40 Socket-Type Fittings) and NSF/ANSI 61 Certified
• Maximum Temperature: 140°F (60°C)
• Safety Notice: Never use with compressed air or high-pressure gases.

Quick Solvent Weld Guide

1. Prepare: Ensure the matching pipe ends are cut perfectly square and completely deburred.
2. Prime: Apply a thorough layer of purple PVC primer to the outer pipe ends and the inner sockets of the 90-degree elbow.
3. Glue: Coat both primed areas with an even layer of medium-body PVC solvent cement.
4. Assemble: Push the pipe firmly into the elbow socket, give it a quick quarter-turn twist to spread the cement evenly, and hold for 30 seconds until the initial bond sets.